Technical Description
The Culique Infrared Skin Mask

Frequency range
Tested 0:01 Hz - 50 MHz

Frequency Wave and Sideband
Transmits all ETDFL frequencies Using Multiple Infrared Light Spectrums when connected to RDPV4 machine. All Dr Rife MOR Carrier Wave and RF frequencies are reproduced through the Positive and Grounded areas of the Mask with +99%† efficiency.

Brightness Settings when Using the Culique Mask with the Culique Controller
Set the Culique Controller to the LOW illumination level to start the treatment. After a while, you can switch to HIGH for more effective Skin treatment protocols. Be sure to keep your Skin open while using the Culique Mask, as the Multiple Mode Infrared Plus frequencies need to reach both Skin. If the light feels too intense, adjust the controller back to the LOW setting.

Brightness Settings when Using the Culique Mask with the RDPV4 Controller

• Configure the RDPV4 to a voltage level of 12.5 V DC if the illumination level is excessively intense. 12.5 V DC is the lowest illumination level. The middle setting is 14.5 V, while the default maximum level is 17.5 V, which is recommended for Skin treatments.
• Be sure to keep your Skin open while using the Culique Mask, as the Multiple Mode Infrared Plus frequencies need to reach both Skin. If the light feels too intense, adjust the controller back to the LOW setting.

Clinic Use, and Cleaning
If using the Mask for multiple people, or for a clinic, wipe down the surface area after use with a cloth. Do not use alcohol directly on the surface. You cannot wash the Mask in a washing machine, as this will damage the electronics.